Pololu Custom Laser Manual do Utilizador descarregar pdf (Página 6)

Gold mirrored acrylic.

Yellow mirrored acrylic.

Clear “silver” mirrored acrylic.

◦ Woods (MDF, balsa, birch, poplar, red oak, cherry, holly, etc.) – we stock 3 mm birch plywood; for other

types of wood, try Midwest Products [http://www.midwestproducts.com/].

Materials we cannot laser cut

We do not or cannot cut the following materials:

• Most metals – We cannot cut most metals. The two exceptions are thin sheets of stainless or spring steel (up

to 0.060" thick). We also stock an acrylic-based, dual-tone plastic with a faux-metal finish on one side. If you

need thicker metal parts, you might consider a water jet cutting service.

• Polycarbonate (PC, Lexan) – we stopped cutting Lexan due to the fumes.

• Any material containing chlorine

• PVC (Cintra) – contains chlorine

• Vinyl – contains chlorine

• Glass – we can engrave glass, but we cannot cut it.

• Fiberglass

• Printed circuit board (FR4 and other material types)

• Carbon fiber

• High-density polyethylene (HDPE) thicker than 1/16" – We are unable to cut HDPE thicker than 1/16", and

HDPE of any thickness melts badly when laser cut.

Pictures of some acrylic colors we stock

Below are pictures of most of the 1/8" acrylic colors we stock. Your monitor will probably not show the colors exactly,

but the pictures should give you some idea of what the colors are like. We do stock other colors and materials: see the

quote request form [http://www.pololu.com/laserquote/new] for a complete list.

3. Materials for Laser Cutting Page 6 of 29

1 2 3 4 5 6 7 8 9 10 11 ... 28 29

Sem comentários

Pololu Custom Laser Manual do Utilizador Página 6